Wheel Fitment Tool (3D Printed & Assembled) by
Preorders will remain open until product sells out. Preorders will begin shipping End of May.
This tool is designed to assist in determining how a wheel diameter, width, and offset will line up with the fender of your car.
This can measure wheels in the following ranges:
- Wheel diameter from 13 inches to 20 inches
- Wheel width from 7 inches to 13 inches
- Wheel offset from -40mm to +40mm
- Compatible with 4 and 5 lug hubs
Please take other factors into consideration such as inner wheel well clearance with the tire, brake rotor and caliper clearance, suspension clearance, etc. This tool will only assist in finding the appropriate offset as the outside edge of the wheel looks with the fender. Wheel diameter is measured by wheel face where the tire seats on the wheel, not including the outer lip. Wheel width is measured by the width between the inside of the wheel lips that retain the tire. The outside location of the lip can be varied by the height and thickness of the lip.
When setting up this tool, please double check accuracy of all measurements by tape measure with the hub mount on a flat surface. The built in measurements should be used as a guide for setup, then fine tuned by tape measure. We are not responsible for incorrectly ordered wheels due to the use or misuse of this product.